Year End Sale: 2 Plugins for $39.99 | Shop Now »

How to Fix a Muddy Bass Guitar

Dec 25, 2019

A muddy bass guitar sounds murky and unfocused, and can leave your mix feeling like it has no solid foundation. We offer 3 tips for remedying this issue.

How to Fix a Muddy Bass Guitar

A muddy bass guitar sounds murky, unfocused and messy. You can fix this by using an EQ to remove low-end rumble and avoid frequency masking, narrowing the low-end of your bass guitar with a stereo imager, and EQing spatial effects.

1. EQ the Low-End Rumble and Frequency Masking

A lot of low-end rumble hangs out below 40 Hz, and depending on the genre, your bass track may not need frequencies this low. It’s a good idea to cut these unwanted frequencies with an EQ like the Q-10 Equalizer. Apply a high-pass filter around 40 Hz and gently roll off the low-end. Make sure that you aren’t cutting away so much low-end that your bass loses weight.

Mud is commonly the result of frequency masking caused by your bass inappropriately interacting with other elements in your mix. When your kick and bass play together at the same time, their fundamental frequencies shouldn’t be dominating the exact same spot.

Carve out space for your kick by applying a narrow bell filter for gain reduction to the 100-200 Hz range of your bass. Use a narrow bandwidth to sweep through this frequency range and lock onto the frequency that allows your kick to shine through.

If your bass loses too much body when you’re attempting to make room for your kick, consider using a dynamic EQ instead of a static EQ. The F6 Floating-Band Dynamic EQ will allow you to set a sidechain input channel for the band you’re using and cause your bass to attenuate only when your kick plays.

2. Sum the Low-End to Mono

Bass guitar is usually recorded in mono, but it’s not uncommon for clients to slam their bass through stereo wideners in an attempt to make their bass fill out their mix. Spreading apart the top-end of your bass guitar with a chorusing effect isn’t a bad idea, but spreading the low-end can lead to potential phase issues when you sum your track to mono.

Duplicate your bass track and apply the C6 Multiband Compressor to each instance of your bass guitar. Set the low-frequency crossover to 100 Hz for both tracks. On one of the tracks, solo the low band, and on the other track, mute the low band. You can now apply the S1 Stereo Imager to the low-end bass guitar track and sum it to mono.

Phase issues usually equate to a loss of impact and energy and can result in muddiness. By summing the low-end of a bass into mono, you’ll be able to hear this loss of power and make up for it with a gentle EQ boost.

Try using a low-shelf filter to boost below 80-100 Hz to reintroduce lost low-end energy. Now, whether the track plays back in mono or stereo, the low-end of your bass guitar will be appropriately balanced.

Note: Frequencies below 80-100 Hz aren’t noticeably directional. Listeners will notice a muddy bass, but likely won’t notice whether or not the low-end of the bass is in mono or stereo.

3. EQ Your Spatial Effects

Applying a reverb or delay to your bass guitar is the fastest ways to ruin a perfectly good bass guitar recording; this doesn’t mean you shouldn’t use spatial effects, it just means you need to be careful with the processing you’re applying.

The main problem you’ll run into using spatial effects is frequency masking and phase issues caused by the wet signal’s low end negatively interacting with the direct signal’s low end.

The H-Delay Hybrid Delay and Abbey Road Chambers both provide filter controls over their wet signals. Apply a high-pass filter to the wet signal to avoid clashing frequencies; keep moving the cutoff frequency up the frequency spectrum until the mud you’re hearing is removed.

Want more quick mix fixes? Get tips on fixing muddy electric guitars.

Want to get more tips straight to your inbox? Subscribe to our newsletter here.

Loading....
More Mixing & Production Tips