Ends Today : Buy 2 Get 2 Free | Shop Now »

ReWire Link Cannot Be Established in Waves Tune

Jun 24, 2024

If you encounter the following message in the Waves Tune plugin: “ReWire link cannot be established; Please check your settings,” please follow these steps.

Please Note:

  • The ReWire software protocol does not work on Apple Silicon processors.
  • If your host is not mentioned in this article, it does not support ReWire. Waves Tune still works in any supported host, but without rewire, you won’t be able to control your host’s timeline from inside Waves Tune’s interface.

Pro Tools

In Pro Tools, the Waves ReWire plugin must be inserted to allow full sync with Pro Tools’ transport and timeline. Since the Waves ReWire plugin has no audio output, you should insert it into an auxiliary track so that it doesn’t use a valuable voice.

  1. Create a new Aux track.
  2. In an empty insert slot, go to the “Instruments” category.
  3. Select the Waves ReWire plugin.
  4. If the message persists, either open a new instance of Waves Tune or relaunch Pro Tools.

Logic Pro

In Logic Pro, ReWire has to be enabled in Settings for Waves Tune to see it:

  1. Go to Logic Pro > Settings > Audio > Devices tab.
  2. Set the ReWire Behavior to Live Mode.
  3. Click Apply.
  4. Quit Logic Pro and relaunch it.

Please note: the option to enable ReWire is not available on Apple Silicon processors.

REAPER

In REAPER, the Waves ReWire plugin must be inserted to allow full sync with REAPERs transport and timeline:

  1. Go to the Add FX menu > ReWire.
  2. Select Waves ReWire.
  3. Click OK.
  4. If the message persists, either open a new instance of Waves Tune or relaunch REAPER.

Cakewalk by Bandlab

In order to establish a ReWire connection in Cakewalk by Bandlab:

  1. Go to Insert > ReWire Device > Uncategorized.
  2. Select Waves ReWire.
  3. Click OK.

If you can’t find the ReWire plugin in your plugin list, please refer to this article: Can’t Find Waves ReWire Plugin in Host Application.